How to Hang Peel and Stick Wallpaper: A Step-by-Step Guide
Peel and stick wallpaper is one of the easiest ways to transform a room, and you don’t need paste, a pasting table or any special skills. With a bit of preparation and a second pair of hands, most people can hang a feature wall in an afternoon. Here’s how we recommend doing it.
What you’ll need
- Your wallpaper panels (they arrive numbered, so you know the order)
- A spirit level or plumb line, and a pencil
- A plastic smoothing tool or a clean, soft cloth
- A sharp craft knife with spare blades, and a metal ruler
- A step ladder
- A helper: two people make the first panel much easier
1. Prepare the wall
Peel and stick wallpaper sticks best to a smooth, clean, dry wall. Wipe away dust and grease, fill any holes and sand them flat. Bumps and rough patches can stop the panels sticking well and leave air pockets that may lift over time.
If you’ve just painted, wait at least three weeks for the paint to cure fully before you hang. We don’t recommend hanging straight onto bare plasterboard or fresh plaster.
2. Mark a straight starting line
Very few walls are perfectly straight, so don’t rely on the corner. Measure 61 cm (the width of one panel) from your starting edge, then use a spirit level to draw a vertical line from ceiling to floor. Your first panel lines up against this, which keeps every panel after it straight.
3. Hang the first panel
Peel back about 30 cm of the backing paper from the top. Line the panel up with your pencil line, leaving a little extra at the ceiling, and press the top in place. Then work downwards, peeling the backing away a little at a time with one hand while you smooth the panel onto the wall with the other. Smooth from the centre outwards to push out any air.
4. Butt-join the next panels
Our panels are butt-jointed: each one sits edge to edge with the last, with no overlap. Line up the pattern at the top, press the edge right up against the previous panel, and smooth down as before. Check the pattern lines up every so often as you go.
5. Smooth out bubbles
Small bubbles usually push out to the nearest edge with your smoothing tool. If a crease forms, gently lift that part of the panel and smooth it again.
6. Trim the edges
Run your smoothing tool into the join between wall and ceiling (and skirting board) to make a crease, then trim along it with a sharp knife against a metal ruler. Change the blade often: a blunt blade tears rather than cuts. Around sockets and switches, turn off the power, loosen the faceplate, and trim the paper so it tucks neatly behind it.
How much extra should I order?
Our wall calculator adds 5 cm to the width and 10 cm to the height of your wall, so you have room to trim. If your walls or ceiling are noticeably uneven, add a few more centimetres. You’ll find the calculator on every wallpaper page in our wallpaper collection.
Still not sure?
Order a sample first to see the colour and finish on your own wall. For our quick checklist, see our How to Hang page, or email us at hello@thebelleimpression.com and we’ll be glad to help.